Fall has finally arrived, which means winter is not far behind. It’s important to have a heater that works properly all season long. Below our heating maintenance company shares 5 tips for preparing your heater, so it can keep you warm when you need it most:
Five Ways to Get the Heater Ready for Winter
To keep your family warm, you may need home maintenance first to prevent heating repair in North Ogden, UT.
If you do require assistance, do not hesitate to get in touch with Anderson HVAC in North Ogden, UT for expert heating service.
• Turn on the Thermostat
Change from cooling to heating, and increase the temperature by a few degrees above room temperature. Remove the cover if the heat doesn’t start within one minute, and ensure the wire connections are secured. Ensure the HVAC system’s power supply is switched on if the connections are tight. You can check the fan, blower, or heat pump if it is still not working.
• Replace the Air Filters
The filters should be changed every few months. Regular cleaning and replacement of filters can keep particles out of your HVAC system, prolong its lifespan, and prevent heating repair. Do not hesitate to get in touch with Anderson HVAC in North Ogden, UT if you require professional service.
• Cleaning
AC Condenser: If your HVAC system is a heat pump, you can cover the condenser to keep it safe from falling icicles. This function can be accomplished with a large trash can lid secured with bungee strings. A board can cover the fan, but not in a moisture-trapping plastic sheet.
Heat Exchanger: Our trained HVAC contractor in North Ogden, UT, should brush and vacuum the heat exchanger every year while it is off. A technician will inspect the heat exchanger for cracks that could cause dangerous carbon monoxide leaks into your home.
Vents and Registers: The best HVAC contractors in North Ogden, UT, recommend dusting your registers and vents before using your heater. This will remove any buildup in your heater’s air. Also, make sure you check your vents for obstructions.
• Quick-Sealing of Windows
You can make a dead air pocket by applying clear plastic film to your windows. You can place the film in rooms that are not used or on windows or patio doors if you don’t like it. This inexpensive method is easy to pay off as heat lost through windows can account for between 10 and 25 percent of your heating bills.
You can shake your windows if you feel heat escaping from them. Before shrink-wrapping, seal the gaps with putty-like rope caulk. It is easy to apply the rope caulk by pressing it into place. Before the next heating season, thoroughly check your windows and caulking.
• Book a Heating Maintenance Appointment
A professional heater tune-up should be scheduled for your heating system at least once a year. This is best done at the start of the heating season. It’s not too late to schedule a tune-up if your heating system hasn’t been serviced in the past 12 months.
Our technician will inspect your system and recommend repairs or replacements to help prevent downtime. They will clean and calibrate the thermostat and tighten the electrical connections.
You will enjoy greater comfort and efficiency during winter by being on top of your heater maintenance. Anderson HVAC can help you schedule your next maintenance visit if it’s past due. Call 801-782-9751 to set up an appointment for a heater tune-up in North Ogden, UT.